How to use 9g micro servo motors and the actuator training b

[Matthew]

Hi,
I am making a small robotic arm for my project which is part of my HNC
Engineering course. I have used flowcode 7 and pic16f1937 microcontrollers before in my studies but never used the servo motors functionality. I purchased some 9g micro servo motors(https://www.oyostepper.com/category-89- ... otors.html) which will be connected to the actuator training board as I thought this would enable me to use multiple servos. I wrote a program in flowcode 7 and it works for the simulation but I can't figure out how to control the micro servos using the potentiometers on the board.
Can you offer any advice?
Tom27

[guidolenz123]

Wrong forum

[Metaphysik]

And far away from Singapore, where the IP is located

[rolf.g3]

Ah, wieder der Schrittmotoren - Onkel... wie schön !

Grüße auf die Südhalbkugel und immer drann denken: Keine Kaugummi auf die Gehwege spucken - wird teuer !!!

C³pO und R2-D2 sowie Lt.Cmdr. Data lassen ebenso grüßen: 0000011100110101000111000110000011111000100100111011 !!


gr