How to use 9g micro servo motors and the actuator training b

[Matthew]

Hi,
I am making a small robotic arm for my project which is part of my HNC
Engineering course. I have used flowcode 7 and pic16f1937 microcontrollers before in my studies but never used the servo motors functionality. I purchased some 9g micro servo motors(https://www.oyostepper.com/category-89- ... otors.html) which will be connected to the actuator training board as I thought this would enable me to use multiple servos. I wrote a program in flowcode 7 and it works for the simulation but I can't figure out how to control the micro servos using the potentiometers on the board.
Can you offer any advice?
Tom27

[guidolenz123]

Wrong forum